Removing Chimney From Attic
If the chimney ends below the roof line it will act like a huge attic bypass allowing heat to escape in to the attic.
Removing chimney from attic. Typically the teardown or chimney removal process happens in a day and the company doing the work will use some type of heavy polyurethane sealing like heavy duty plastic to make the open area airtight and watertight. If you are absolutely sure the chimney is no longer used by any of the homes fuel-burning appliances then yes by all means take the chimney down below the roof. I know that removing an old unused chimney from a house is done from the top down.
Then roof built over hole where chimney was using slate to match rest of room. Took it down to inside the attic and covered over in there. External chimney stack removal can be done from outside the building and if done carefully need not disrupt any internal decoration.
Im just wondering if its even thinkable to remove a mid-section from the chimney while reinforcing under the first removed layer of bricks taken out would be at the ceiling of the top floor on the diagram as its being taken down to support the top part of the chimney around 10 feet of it. An internal chimney breast can be removed at ground andor first floor without having to remove the external stack. The standard practice is to start at the roof and work your way down dropping the loosened bricks into the chimney as you go.
Tammy was inside the attic removing. Removing the chimney without providing a new flue for the water heater could fill the home with deadly carbon monoxide gas. If the chimney is abandoned seal off the top completely.
Just had a chimney removed from an 1880s house. One thing to be careful about though. If the roofing is worn and nearing time for replacement removing the old chimney may be much more desirable.
If it is in the center of the house only remove the top of the flue thru. To remove the chimney below the roof line the chimney must also be abandoned or only be used to vent gas appliances that are connected to a metal flue liner. This leaves a few tons of brick mortar and possibly flue tiles to haul out of the basement.
If youre not trying to retain it by shoring it up properly for architectural reasons or simply because you dont want to repair the hole in the roof removing it will leave behind the project will always involve safely taking down the chimney. Before removing a chimney find out if your furnace and water heater are gas and vent out the chimney. Theres no easy way to remove a chimney.
Removing the chimney starts from the top down. Then reside over where the flue was. Among the tasks of updating the house was removing the old chimney and it was this task that exposed a secret on Saturday Aug.
In that scenario the chimney may be easily removed from the attic. Its a dirty messy somewhat dangerous job.
